1. Photograph any visible fingerprints that you observe.
2. Carefully dip the brush into the appropriate powder. Apply a small amount of powder to the tip of the brush.
3. Apply the powder to the surface with a light twirling motion over the area to be processed. If a heavy deposit appears on a fingerprint, gently brush off the excess powder with a light twirling motion.
4. Photograph any latent fingerprints that have been developed.
5. Apply a short piece of lifting tape. This must be pressed well onto the surface.
6. Slowly remove the lifting tape from the surface and place it on a backing card that is of contrasting color to the powder being used.
7. Properly fill out the back of the backing card with the proper information.
This information was derived from:http://www.csigizmos.com/products/latentdevelopment/processing.html
No comments:
Post a Comment